View ITRAX02_1257892.PDF datasheet online --- IC-ON-LINE

Datasheet File OCR Text:

* Ultra Low Power Consumption * Tiny Form Factor * Market Leading Performance
ITRAX02 Key Features:
* Tiny PCB form factor - 26mm x 26mm x 4.7mm (including RF shield and system connector). * Ultra-low power consumption - 130mW @ 2.7V in continuous operation * Very Fast TTFF * Sensitivity -150dBm (Tracking) * iTALK and NMEA0183 protocols * Versatile interface ports * Accurate 1PPS timing output * ITRAX02/8 - 8MBit Flash Memory - iSUITE SDK Software Development Kit * ITRAX02/4 - 4MBit Flash Memory - NMEA Engine
Fastrax's ITRAX02 GPS receiver modules enable the implementation of full-fledged positioning features into any appliance faster and with less effort than ever before. Offering industry-leading benefits in performance, size, power consumption and versatility, the ITRAX02 receivers are ideally suited for both industrial tracking systems and battery-operated consumer products like mobile phones, asset tracking devices, handheld computers and sports accessories.
Market Leading System Performance
Ultra-low, user configurable power management makes ITRAX02 the lowest power consuming, complete 12-channel GPS receivers on the market. Nevertheless, there are no compromises in performance. The ITRAX02 receivers have a navigation sensitivity as low as -150 dBm making them applicable even for extremely demanding applications and environments.
Cutting component costs
Space and costs are reduced due to the cutting-edge technology architecture in the ITRAX02 receivers. All navigational data is stored in Flash memory with simple commands and thus no back-up battery is required. This benefit can easily be converted to smaller component costs and smaller design - crucial parameters for many projects.
ITRAX02/8 - Versatile Programmability
The ITRAX02/8 features 8MBit Flash memory allowing versatile programmability with the iSuiteSDK (Software Development Kit). Application costs are reduced significantly when no external processor is needed and the ITRAX02 is used as a microprocessor. With fewer components, cost and application size are reduced.
ITRAX02/4 - cost efficient performance
In applications where the industry standard NMEA0183 protocol is sufficient and programmability is unnecessary, the ITRAX02/4 with 4MBit Flash memory, is a cost efficient and high performance alternative.
Quick Start with Easy-To-Deploy Solution
The addition of an antenna and power supply is all that is needed to make the ITRAX02 operational. The Fastrax support team can provide antenna design application notes to aid in further refinement of the antenna design for specific applications.
Specifications
General: L1 frequency, C/A code (SPS) 12 independent tracking channels Separate search & acquisition engine Based on two-chip GPS solution - RF chip, uN8021 - Base band chip, uN8031 Update rate: Accuracy: 1 fix/s or user configurable Position: Velocity: Time: Reacquisition: TTFF: 3m (CEP), 6m 2DRMS 0.2 m/s (50%) 20ns RMS (static mode) Processor: Protocol: I/O Ports: Antenna: Power Drain: External, passive or active 130mW @ 2.7V (in continuous mode) (Active antenna power not included) Dual Asynchronous data ports 16-bit GPIO SPI-Interface Dual Pulse Measurement inputs 1PPS Output NMEA-0183 V3.0 Proprietary iTALK binary protocol Proprietary, 32MIPS integrated 16-bit DSP-core RISC-like programming under Pre-emptive Real Time Operating System Control (VSDSP RTOS) Flash Memory: ITRAX02/8: ITRAX02/4: Dimensions: 8MBits Flash 4MBits Flash
100ms typical (signal reacquisition) Cold Start: Warm Start: Hot Start: Quick Start: 50 s typical 35 s 8s 3s 4G 4 m/s3
Dynamics:
Acceleration: Jerk:
26 mm x 26 mm x 4.7 mm (Including RF shield and connector)
Sensitivity:
-150dBm (tracking)
Weight:
4g
Operating Voltage: 2.7V...3.3V (linearly regulated) Operating Temp: Antenna Supply: -40C...+85C Same as board supply or Separate external supply (e.g. 3.3V)
System Connector: AMP 4-353515-0 (RF and I/O) 2 x 20 pin, 0.5 mm pitch Mating Connector: AMP 4-353512-0
Other Fastrax GPS products
Fastrax other GPS products include modules like uTracker02 and uPatch02. Both products include a ITRAX02 GPS receiver and on-board regulators. The
uPatch02
uTracker02 has furthermore a MCX antenna connector for easy integration while the uPatch02 has RS232 drivers and a already integrated and optimized
Patch antenna. For easier evaluation Fastrax offers an ITRAX02 Evaluation uTracker02 kit that includes a universal power supply, two serial cables, an active antenna,
a user's manual and a CD with documentation and the GPS WorkBench.
For programming the ITRAX02/8 Fastrax offers a iSuiteSDK (software
iTrax Evaluation Kit
development kit). In addition to the software the iSuiteSDK includes two days of hands on training and e-mail support during development. For application that use an external host processor Fastrax offers a free iSuiteHDK (host development kit) to registered users at www.fastrax.fi. The iSuiteHDK includes documentation and source code to Fastrax binary protocol, iTalk.
Adeline Oy 030902
iSuiteSDK
iSuiteHDK
Separate product descriptions can be found at www.fastrax.fi

▲Up To Search▲

Price & Availability of ITRAX02

	To Download ITRAX02 Datasheet File
If you can't view the Datasheet, Please click here to try to view without PDF Reader .